paranero.blogg.se - Therm pro timer pt04 instructions

: Press and hold for 2 seconds to turn 0N/0FF the unit.

RESET: Press once to reset the remote sensor. To access CHANNEL SELECTOR and RESET buttons, you need to unscrew the cover as per Fig.ĬHANNEL Selector (1,2,3): Slide to set Channel 1,2 or 3. Built-in rechargeable lithium battery: Type 18650.Outdoor remote sensor (transmitter) features

Indicates the Temperature & Humidity is in a no change trend.indicates the temperature & humidity is in an increase.If you do not press the button for 15 seconds, the backlight will be automatically turned off. Note: Both ALL TIME and 24 hours represent the time since you last manually cleared the history data or installed a new battery. Touch this button once to set the maximum and minimum data record time interval between ALL TIME or 24 hours. ☏/☌/History: Press to select the temperature display in ☌ or ☏ When the display shows the maximum or minimum temperature and humidity. MAX/MIN/CLEAR: Touch once to display the maximum or minimum temperature and humidity Press and hold to clear the history data. Temperature display unit: ☌ and ☏ selectable.ĬHANNEL/SYNC: Press once to display the temperature and humidity readings from up to 3 outdoor remote sensors Press and hold this button to enter the synchronization mode.Tabletop, wall-mountable and magnet-mountable design.Battery Compartment: Holds 2 AAA batteries to power the unit.LCD display: Displays the current outdoor humidity/ temperature and indoor humidity/temperature.* Although the remote sensor is designed to be rainproof, it is preferable to place the sensor in a dry location that avoid direct rainfall and sunlight for more precisely and quickly environmental temperature and humidity. 9.Power: 2 X AAA 1.5V for base unit and 18650 lithium battery 3.7V for remote sensor.Humidity tolerance: 12% from 30% to 80% +3% below 30% and above 80☄.(range maybe shorter based on interference present). Transmission range up to 300 feet in open area.

Dispose of the unit legally and recycle when possible.

The unit or parts of the unit might be a choking hazard.

Do not subject the unit to excessive force, shock, dust, temperature or humidity.

Remove the base station from the refrigerator or the metal object or place the base station and remote sensor as close as possible.

If the base station is attached to a refrigerator or a metal object by magnet, the transmission may be shorter.

Place the base station and receiver away from these devices.

Signals from other electronic devices may cause interference.

Relocate the base station or the remote unit until connection is established again.

Repeat the synchronization process as described below.